![]() Protocol Reparse is an advanced technique that should be skipped if not fully understood. ![]() ![]() This is valid when in active Protocol Reparse mode. The third array is the Serial Buffer Data u array. Reference to a component without specified Attribute can create for long and potentially frustrating debug sessions. These (p.b) need to be used with caution and mindful purpose. The p page array which takes page index as index The b component array which takes component. ![]() Separates Page, Component and AttributesĪlso used with page index and component array. Parenthesis are not allowed to create complex statements. See if (see 3.25) while (see 3.26) and for (see 3.27)Ĭonditions may be joined with no spaces between conditions, left to right evaluationĬonditions enclosure begins with open parenthesis (Īnd ends with closing parenthesis ) at end of line. Ie: decimal: 255 or hex: 0xFF or ansichar: ÿ or binary: 11111111 : Basic, Discovery or Enhanced : Basic or Enhanced : Enhanced or IntelligentĪll instructions over serial: are terminated with three bytes of 0xFF 0xFF 0xFF : Basic : Discovery : Enhanced : Intelligent : All They are categorized into only a few categories These are the set of commands that Nextion can use.
0 Comments
Leave a Reply. |